Heavy Truck & Equipment Operations

Common Safety Rules for Drivers and Operators

Operation of heavy trucks and equipment such as excavators, loaders, graders, rollers, and bulldozers should always be done by highly skilled operators who have demonstrated the ability and necessary skills to operate safely. Ground-based workers should be trained in how to work safely around moving trucks and equipment, especially how to stay clear. Unsafe practices by the operator, those on foot or in other vehicles nearby can quickly create dangerous situations. Serious injuries often occur when equipment strikes a worker. With collisions, the oft chance of equipment being rolled over is a possibility.

Here are a few common safety rules for drivers, operators and ground-based workers to consider:

  1. Good communication is essential.
    A standardized set of hand signals should be used by the operator and signal person. Only one person gives hand signals to the operator. Operators should always know exactly where all ground-based workers are located, and the wearing of high visibility vests will help the operator to locate them quickly. The equipment should have a backup warning alarm that can be heard by all nearby workers. Two-way radios are also valuable communication tools. Eye-to-Eye contact is part of communications between pedestrians and operators.
  2. Heavy equipment must have a rollover protective systems (ROPS)
    You should always meet OSHA requirements. The ROPS is designed to protect the operator if the machine tips over. A seat belt must be worn so that the operator will not be thrown out of the seat during a rollover or upset situation. If working on slopes, try to avoid moving across the face of the slope. Try to operate up and down the slope face if possible. Use extreme caution when operating near open excavations.
  3. Wear hearing protection when required.
    If it has been determined that noise levels around the equipment could potentially cause hearing loss, always use protective plugs or muffs when working on or around the equipment.
  4. Never jump onto or off the equipment.
    Operators should always use the three-point contact rule when climbing onto or off heavy equipment. The three-point rule means having both feet and one hand, or one foot and both hands in contact with the ladder access at all times.
  5. Inspect and service the equipment regularly.
    Complete equipment service in accordance with the manufacturer’s recommendation. Periodic safety inspections on all components of the equipment should be done regularly by qualified personnel. Inspect the steering system and brake systems carefully. A pre-shift walk around inspection by the operator is highly recommended.
  6. Utilize STOP Work Authority when conditions feel unsafe.
    When the task is not going as per plan, the instructions are lacking, or the task is new and you feel unsure then it’s time to utilize your STOP Work Authority until matters are settled a unified plan is in place to continue.

Injury accidents involving heavy trucks and equipment on construction sites have a higher probability of resulting in a fatality than many other types of accidents. It is critical to follow all of your company’s safety rules and procedures when operating or working around heavy equipment.

Safe operation of all truck, heavy equipment and vehicles starts with good communication of the plan and route.

Leave a Comment